VENTUM 505 adhesive for ceramic tiles
Packaging: 25 kg
Color: Grey
Maximum grain size: 1.25 mm
Mix shelf life: 4 hours
Open time: 15 minutes
Tile adjustment time: 10 minutes
Drying time: 24 hours
Amount: When working with a 6x6 mm trowel at a 60° angle ~ 2.8 kg/m², applied to a flat surface
Recommended layer thickness: 3 mm to 6 mm
Adhesion minimum: 1.0 MPa
Frost resistance: 50 cycles
Operating temperature: +5°C to +30°C
Operating temperature: -50°C to +70°C
Composition: Dry mix based on cement, mineral fillers, fractionated sand, and modifying additives. This mix is used for ceramic, granite tiles, natural and artificial stone. Suitable for vertical and horizontal surfaces, such as limestone, concrete, aerated concrete, brick, and other mineral bases. Used for tile installation, filling gaps between tiles, and leveling the surface up to a 5 mm layer. Suitable for both interior and exterior work.
Base preparation: The base must be solid and free of dust, dirt, oil, and other contaminants. Voids deeper than 5 mm must be pre-leveled with leveling compounds. For high-absorbing bases, it is recommended to apply penetrating primer before processing.
Mix preparation:
Take the specified amount of water (5.75–6.75 L for a 25 kg bag).
Add the mix to the water.
Mix thoroughly with a construction mixer or special tool until a homogeneous mass is obtained.
Allow the mix to rest for 5–10 minutes (technological pause).
Mix again.
After this, the adhesive is ready for use for 4 hours (with continuous mixing).
