Tile adhesive VENTUM 505
Packaging: 25 kg
Color: Grey
Maximum Grain Size: 1.25mm
Solution lifetime: 4 hours
Open time: 15 minutes
Tile adjustment time: 10 minutes
Drying time: 24 hours
Consumption: 6x6 mm trowel at an angle of 60° – ~ 2.8 kg/m² on a flat surface
Recommended layer thickness: 3 mm to 6 mm
Adhesion not less than: 1.0 MPa
Frost resistance: 50 cycles
Work temperature: from +5°C to +30°C
Operating temperature: -50°C to +70°C
Composition: A dry mixture based on cement, mineral fillers, fractionated sand and modifying additives. This composition is used for laying ceramic, porcelain stoneware, as well as natural and artificial stone slabs. It is suitable for vertical and horizontal plastering, concrete, aerated concrete, brick and other mineral substrates. Suitable for interior and exterior applications.
Preparation of the substrate: The substrate must be solid, thoroughly cleaned of dust, dirt, oils and other contaminants. Unevenness with a depth of more than 5 mm must be leveled with plaster mixtures beforehand.
Preparation of the solution:
Take a precisely measured amount of water (5.75-6.75 liters per 25 kg bag).
Pour the mixture into the water.
Mix with a mixer or drill with an attachment until smooth.
Pause for 5-10 minutes for the solution to mature.
Stir again.
After that, the glue is ready for use within 4 hours (with periodic stirring).
