VENTUM 505 tile adhesive
Packaging: 25 kg
Colour: Grey
Maximum grain size: 1.25 mm
Mix life: 4 hours
Open time: 15 minutes
Tile adjustment time: 10 minutes
Drying time: 24 hours
Consumption: 6×6 mm trowel at 60° angle — ~ 2.8 kg/m² on a smooth surface
Recommended layer thickness: 3 mm to 6 mm
Adhesion not less than: 1.0 MPa
Frost resistance: 50 cycles
Working temperature: +5°C to +30°C
Operating temperature: −50°C to +70°C
Composition: Dry mix based on cement, mineral fillers, fractionated sand, and modifying additives. This composition is used for laying ceramic, porcelain stoneware tiles, as well as plates made of natural and artificial stone. It is suitable for vertical and horizontal plastered, concrete, aerated concrete, brick, and other mineral substrates. The adhesive is also used for filling grout joints and leveling the surface up to 5 mm. Suitable for internal and external work.
Substrate preparation: The substrate must be strong, thoroughly cleaned of dust, dirt, oils, and other contaminants. Irregularities deeper than 5 mm must be pre-leveled with plastering mixes. For highly absorbent substrates, pre-treatment with deep-penetrating primer is recommended.
Mix preparation:
Take the precisely measured amount of water (5.75–6.75 L per 25 kg bag).
Add the mix to the water.
Mix thoroughly with a building mixer or drill with an attachment until a homogeneous mass is obtained.
Wait 5–10 minutes for the mix to mature.
Mix again.
After this, the adhesive is ready for use within 4 hours (with periodic stirring).
